Spraying Thompson’s Water Sealer involves using an HVLP paint sprayer or spray guns to expel a fine mist of sealer to the surface. It applies faster thin and light coats, which makes the sealer dry faster. You don’t have to mix or shake Thompson’s water sealer before application unless you are using a sprayer. The manufacturers advise against mixing, thinning, or diluting the sealer with any other type of solvent. These sprayers will usually allow for a high level of control over pressure and volume, so they’re best suited for covering large surfaces with a wide nozzle. Battery-Powered Sprayers The sprayer has a bowl-shaped mouth, which makes it easier to pour fluids in without it spilling. Even though the body is orange, it is translucent, so you can see what level the liquid is and top it up as needed. Remember to always follow the specific instructions provided by Thompson’s Water Seal for the best results. Can Thompson Water Seal be applied with sprayer?

As long as the patio is thoroughly dry and clean of debris before application, it can produce a non-slip, low-sheen finish which protects the slabs from water, stains and wear. The exact area that one bottle can cover is dependent on the porosity of the patio and how the seal is applied.The Bond It Patio Paving Sealer is also relatively effective against the growth of mould and algae. Although it may not stop it from growing altogether, customers have reported noticing a dramatic decrease in the amount of mould present on their patio.

One of the best sealants to buy on a budget, the Bond It Patio Paving Sealer comes in a 5 L bottle and brings out the natural colour of paving stones without breaking the bank. Allow the sealed surface to dry completely as per the manufacturer’s instructions before subjecting it to foot traffic or other activities. Applying two coats ensures better coverage and penetration into the surface, enhancing the sealant’s ability to repel water and protect against moisture damage. It’s important to follow the manufacturer’s instructions and allow sufficient drying time between coats. Once you have finished applying the sealer, clean the sprayer thoroughly according to the manufacturer’s instructions. This typically involves rinsing the tank, wand, and nozzle with water or a recommended cleaning solution.

In terms of safety, this also has a pressure release valve, similar to the other products on our list, but that is where the similarities end. While this pressure sprayer can be used to apply a range of products, it is not meant for stains or seals with high viscosity. Fortunately, Thompson’s Waterseal has low viscosity, so this product works great.

The first thing we noted while applying the product to a pair of leather boots, which is simple with the included cotton terry applicator pad, is how soft and shiny it makes the leather. And there’s no chemical smell; this product can be applied inside since there are no fumes to worry about, and it doesn’t require spraying. After allowing the leather to dry, our tester buffed off any extra protectant left on the surface and let it sit overnight. Lateral penetrating damp describes what occurs when an external wall becomes saturated and subsequently transmits that moisture to the inside of a building, usually exhibiting as damp patches on the plaster and other decorative finishes. The problem arises for two basic reasons: However, Thompson’s water seal manufacturer recommends using a plastic sprayer with a brass wand attachment when applying their products. To make things easier, the seal has a slightly milky colour when wet, which makes it possible to see which areas have already been covered. One 25 L bottle should be sufficient for the majority of spaces.There are budget-friendly, battery-operated and pump-action sprayers for water-based products for light-duty jobs. Airless sprayers will cover a larger area in a shorter time as the internal pump produces a much higher operating pressure. In terms of conditions, most sealers shouldn’t be applied if either the air or surface temperature is below 5°C. You should also avoid applying the sealer if temperatures are above 30°C. HVLP & airless sprayers are generally used for industrial painting and are great at evenly covering vertical surfaces.