Note: Make sure you are using the 6031 flat tear drop shaped welding tip when using the flat FiberFlex rods. So looking at this has left me with the prospect of trying to re-create one in Fiber glass without destroying a Mint original in the process. You may want to paint the dash with one of Sem interior paint products, This will ensure of a exact color match. Wipe down the entire dash again and if there are any high spots from the welding stick, you can either re-melt it to reduce its height or sand it down.

This filler comes with a small tube of hardener and you won’t be using more than half of it for the entire job. This is the same welding material that is used to repair the TPO plastic used in many bumpers on today's cars.Take extra care to remove the tape cleanly so that you don’t peel off the paint or undercoating with it. Once the color has been reached use very small amounts of black and white to achieve the shade that you desire. It also helps to pause between sprays to see how the product settles so you can make adjustments in your spraying technique as you go.

This makes an excellent filler for padded dashboard repair since the sanding is normally done by hand. If you notice some high spots or areas with a rough or porous texture, wait at least one hour before attempting to lightly sand it using 150 grit paper. Keep the tip of the iron on one side of the stick just long enough to soften it up and then flip the stick so that the melted side is now facing into the groove. FiberFlex Welding Rods with the airless plastic welding side of a nitrogen plastic welder or an one of our other airless plastic welders.The Fiber-Flex sticks melt fast and become very sticky, so this will make your repair go many times faster when compared to polyurethane rod. It is more expensive than many other aerosol spray paints/under-coatings, but you’re paying for the high quality of their products. You should keep channeling through each crack until you have penetrated far enough into the foam so that you can no longer see any separation.

If you notice the filler coming off the dash in small chunks around the edges of the repair, it may be caused by sanding with too much pressure or sanding in a direction toward the repair that lifts and shears it. At the end of the video, we demonstrate how to use Polyvance’s Flextex VT to re-texture the dash after it has been repaired. This initial cleaning will now be followed with the Filler Prep solution, which will help the filler material to bond with the dash surface. Squeeze out about an inch long ribbon of hardener next to the filler on the cardboard and begin mixing both materials into a uniform color, which should be a light blue.A cracked dashboard indicates a structural issue beyond the abilities of a standard leather or vinyl filler. The first step is to clean the surface with 1000 Super Clean plastic cleaner to remove any silicone dressings that may have been applied. com/en 4x4 and SUV spare parts - Accessories Equipments - Toyota, Nissan, Mitsubishi, Jeep, LandRover, Suzuki, Peugeot, Renault . Moving the sandpaper in small circles along the edge of the filler with light pressure can also help with this problem. Many companies that sell plastic welding supplies recommend using a plastic fill material that matches the plastic you are trying to repair.