Algeria, Angola, Anguilla, Antigua and Barbuda, Argentina, Aruba, Austria, Bahamas, Barbados, Belgium, Belize, Benin, Bermuda, Bolivia, Botswana, Brazil, British Virgin Islands, Brunei Darussalam, Burkina Faso, Burundi, Cambodia, Cameroon, Canada, Cape Verde Islands, Cayman Islands, Central African Republic, Chad, Chile, Colombia, Comoros, Costa Rica, Côte d'Ivoire (Ivory Coast), Democratic Republic of the Congo, Denmark, Djibouti, Dominica, Dominican Republic, Ecuador, Egypt, El Salvador, Equatorial Guinea, Eritrea, Ethiopia, Falkland Islands (Islas Malvinas), Finland, French Guiana, Gabon Republic, Gambia, Ghana, Greenland, Grenada, Guadeloupe, Guatemala, Guinea, Guinea-Bissau, Guyana, Haiti, Honduras, Hong Kong, Iceland, Indonesia, Italy, Jamaica, Kenya, Laos, Lesotho, Liberia, Libya, Macau, Madagascar, Malawi, Malaysia, Mali, Martinique, Mauritania, Mauritius, Mayotte, Mexico, Montserrat, Morocco, Mozambique, Namibia, Netherlands Antilles, Nicaragua, Niger, Nigeria, Norway, Panama, Paraguay, Peru, Philippines, Puerto Rico, Republic of the Congo, Reunion, Rwanda, Saint Helena, Saint Kitts-Nevis, Saint Lucia, Saint Pierre and Miquelon, Saint Vincent and the Grenadines, Senegal, Seychelles, Sierra Leone, Singapore, Slovenia, Somalia, South Africa, Suriname, Swaziland, Switzerland, Taiwan, Tanzania, Thailand, Togo, Trinidad and Tobago, Tunisia, Turks and Caicos Islands, Uganda, Uruguay, Venezuela, Vietnam, Virgin Islands (U. Arduino Voltage reference: Both the Uno and Nano have a built-in voltage reference: Find out how to make it more accurate. The nice thing is that the ATtiny85 can be programmed without needing another Arduino or a programmer. How to use Arduino millis to make Delays, One-Shots and simple Schedulers plus analysis of millis code; Plus - Find out why it Lies (a bit)!

Tools > Board > ATtiny Microcontrollers > Attiny25/45/85 - Tools > Processor > ATtiny85 - Tools > Clock > Set to the correct CPU clock (e. h) and replace define USB_INTR_PENDING GIFR with any value above 0x40, like define USB_INTR_PENDING 0x41. the USB circuit including Zener LED (current permanently flowing between +5V, the D- pull-up resistor and the zener diode). hex , since this is what you most likly need (6 second delay only at power-up and fixed the forever loop bug for D- pull-up resistor modfication).I know that the above is not at all a good explanation but I don't know much about this stuff so if anything is unclear please just ask counter questions and I will do my best to clear it out.

Open cygwin to the firmware directory (it should include a Makefile and the configuration directory). Kickstarter USB Development Board is an ATTiny85 based microcontroller development board, which will provide you simple programming through the support of the Arduino-IDE 1. The diode between the USB and 5V shall have the cathode (+) connected to +5V and the anode (–) connected with USB V+.And hit upload button and you'll get a message at very bottom on arduino ide to plug the device within 60 sec then plug the device and if everything worked fine then you'll get a message micronucleus done thank you that means code has been uploaded and your led will start blinking.