Macdee Dual Flush Outlet Valve

Product Information

The Macdee dual flush valve is Water Regulations Advisory Scheme (WRAS) approved so you can rest assured of its quality and safety. The reason it is not refilling is that, possibly, the inlet valve is one of the new generation of eco-friendly valves that is designed not to open until the water drops to a certain level. regarding fitting I assume I need to turn off the water - do I have to turn off the stopcock under the sink and then drain the attic tank (e. Look out for water saving features, quiet operation, WRAS approved, and ones that are suitable for high and/or low pressure systems, as well as the option of brass or plastic shanks. Now use a pencil or something and push the little leaver back down, this should flush the toilet and give you an idea how it works.

Inside you will see its a very, very basic design with what is effectively a bicycle brake cable from the push button unit, pulling on a little pully device which lifts the plunger at the base. It may be push in the left side as pictured or pull out the right side - when it comes off, all will become clear, it has a keyhole shape inside it. It's 2014 and the problem still occurs and WD 40 still works, but just make sure you have a good look at the layout of the little plastic box before you take it apart!Read more about the condition New: A brand-new, unused, unopened and undamaged item in original retail packaging (where packaging is applicable). The unit is a Macdee AFV40100 flush valve - I can't see any markings on the inlet side, so I don't know who the manufacturer of that is - I assume the same. Maybe this bit was overkill but I also disconnected the cable on both ends and cleaned the visible parts - the was some gunk and, after taking the spray diffuser off the WD40 can I forced a whole load of WD40 down inside the cable sheath - again pulling the cable a couple of dozen times to move the WD40 around.

I have had a look at the valve inside the cistern, but was not sure how to disconnect the hose - or the valve for that matter.Be sure you note disassembly positions so its easy to get back together, bit of oil (3 in 1 is better than WD in my opinion) down this end of cable. Inside the bowl there is a hex-head stainless bolt on a stainless washer, which in turn is on top of a rubber washer. Phone MT AGENCIES in finglas and ask them for your nearest agent for the Aquasave bottom entry inlet valve low pressure. For those who are wondering if this will replace the now out of production AFV40100 or AFV40200, the answer is YES it will!