Either party can transfer the benefit of this Contract to someone else, and will remain liable to the other for its obligations under the Contract. The Supplier will be liable for the acts of any sub-contractors who it chooses to help perform its duties. UKCA (UK Conformity Assessed) Meets UK health, safety & environmental protection directive requirements. We can make changes to the Goods which are necessary to comply with any applicable law or safety requirement. We will notify you of these changes. Smithers of Stamford Ltd, 6-8 Broad Street, Stamford, Lincs PE9 1PG United Kingdom. Tel 01780 435060

To limit the current to 10mA, a 220 ohm resistor is placed in series with the leds and the supply voltage is set to 30 volts. FCC (USA Only) Complies with part 15 of FCC rules. Safe to use without interfering with other electrical devices. The Goods will become your responsibility from the completion of delivery or Customer collection. You must, if reasonably practicable, examine the Goods before accepting them. Leds are fairly robust devices, but nonetheless you should try and avoid overheating them during the soldering process.Drill two holes through the cork. The drill diameter (1mm) should be slightly smaller than the diameter of the stiff wires on the led heart.

If we have not offered to collect the Goods, we will not make the reimbursement this is at customers' cost. The power source is a 9 volt battery and this is boosted to 30 volts by an adjustable step-up switch mode boost module based on an XL6009 chip. Using a rotary sanding attachment in a rotary tool, enlarge the top half of the hole until the copper tubing fits snugly. The Supplier does not exclude liability for: (i) any fraudulent act or omission; or (ii) for death or personal injury caused by negligence or breach of the Supplier's other legal obligations. Subject to this, the Supplier is not liable for (i) loss which was not reasonably foreseeable to both parties at the time when the Contract was made, or (ii) loss (eg loss of profit) to the Customer's business, trade, craft or profession which would not be suffered by a Consumer - because the Supplier believes the Customer is not buying the Goods wholly or mainly for its business, trade, craft or profession. The led heart is formed by soldering individual leds together in series. The heart is made in two sections and these sections are joined later to form the shape of the heart.

Make the led heart

be reasonably fit for any particular purpose for which you buy the Goods which, before the Contract is made, you made known to us, expressly or by implication, regardless of whether that is a purpose for which goods of that type are usually supplied (unless you do not actually rely, or it is unreasonable for you to rely, on our skill and judgment) and be fit for any purpose held out by us or set out in the Contract; and Uk and Europe Prices are including VAT. 24 A - USA and international we do not charge VAT on your products, this VAT amount is taken off when you add your country destination. Now solder a string of 7 leds together on the left hand side of the template again following the polarity indicated on the template. RoHS Restriction of Hazardous Substances. Minimises the environmental impact of waste electrical and electronic equipment (WEEE) by reducing the quantities of four heavy metals and two brominated flame retardants. Specifies allowed limits of lead, cadmium, mercury, hexavalent chromium, polybrominated biphenyls (PBB) and polybrominated diphenyl ethers (PBDE).