Renogy Boot Dryer Shoe Dryer, Glove Dryer & Boot Warmer with Heat Blower, Portable Adjustable Rack and Timer, Folding Design & Quick Drying for Shoes, Gloves, Hats, Socks, Ski Boots

Product Information

If ignition doesn’t occur within 2-3 attempts, place your thumb over the large hole directly behind the retaining washer and relight. Once lit, leave your thumb over the hole until the heater warms up (about 15-30 seconds). There will be a small blue flame in the center tee. When the Ozone Deodorizing Feature is operating, a faint bleach-like smell may be detected. This is both safe and normal. It indicates the unit is working as intended. PEET Deodorizer Module (M15O3)

Product Instructions and Guidelines | PEET Shoe Dryer Product Instructions and Guidelines | PEET Shoe Dryer

Function: drying, warm, eliminate bad odor and sanitize shoes! Protecting your shoes from humidity! Warm your boots in cold winter morning. To dry gym shoes or athlete’s foot shoes. Suitable all types of shoes and boots, cotton slippers, leather shoes, canvas shoes, work boots, snow boots, and sneakers.Always use Dryers in the open position. The closed position is intended for travel only. Hydration PEET Dryer (M09) Place each of the Ultra Dryers into any pair of shoes, boots, skates or cleats (logo side facing up). Invert the PDM and insert the top vent caps at a downward angle into the footwear. O3 is heavier than air and will fill and treat the footwear.

Dryer Comparison - October 2023 Best Heated Shoe Dryer Comparison - October 2023

Odor Elimination and Sterilization: Our boot dryer not only banishes odors caused by moisture but also effectively eliminates bacteria, guaranteeing your shoes are fresh and clean for both comfort and foot health Place your footwear upside down over the Footwear DryPorts. Make sure the toe is higher than the heel so that the footwear will dry thoroughly. Loosen tongue and laces for a loose fit between the footwear and the AirChambers. This will allow air to circulate properly. The personal hydration bladders should not have liquids still in them when placing them on the Hydration PEET Dryer. The dryer is designed to effectively remove residual liquid that’s left behind to prevent the growth of mold and mildew. The PEET® Dryer is designed for easy use and long service. When you follow these simple instructions and guidelines, the PEET Dryer will dry your footwear or gear safely and efficiently. Drying time depends on material and saturation. ​ ELIMINATES DAMP & ODOR: Got your shoes wet in the rain? Don’t be upset. boot dryer is ready to restore your soggy shoes to dryness and comfort. Optimum heat circulation can not only dry shoes, dehumidify and keep warm, but also destroy the breeding ground of bacteria in shoes to achieve the effect of sterilization and deodorization.Return a healthy foot and let the shoes full of the smell of sunshine.Fold down both prongs away from their holder until you feel resistance and remove the electrical cord. Slide the plug housing off the cord. Do not place the PEET Dryer close to a second heat source, such as a furnace register. Go! PEET Dryer (M04P) Intelligent Timer】Set different working time for different kinds of shoes (up to 99 minutes). Easy to reduce power consumption.

Boot Dryer Shoe Dryer Glove Dryer Boot Warmer with Heat

Eliminates Damp & Odor】Optimum heat circulation effectively eliminates moisture, damp, sweat, and odor in shoes. Getting caught in a rain? Don't be upset. Renogy boot dryer is ready to restore your soggy shoes to dryness and comfort. Using the thumb and first finger on your dominant hand, grab the prongs. While squeezing them tightly together, grab the plug housing firmly between the thumb and first finger of your other hand. Firmly slide the housing away from the prongs. The drying feature will remain on the entire time it is plugged in, as indicated by the red LED ON light.ODORS ELIMIATING】Built-in ozone deodorizer system helps to eliminate the odors caused by sweat and bacteria, preventing the growth of mold. The PEET Dryer will get warm, reaching its maximum temperature in 10 minutes, but it does not get hot. This product uses natural thermal convection technology; there are no fans or moving parts, therefore it will not blow hot air or make noise. Slide the HIGH/LOW selector to the desired ozone setting. In HIGH mode, ozone is generated until the PDM is turned off. In LOW mode, the PDM cycles on and off generating ozone O3 50% of the time when the PDM unit is turned on. Best for use in occupied smaller rooms. LOW MODE is recommended for routine, moderate odor and for use in smaller spaces.