ACED Moon Lamp 2023 Upgrade with Timing 3D Printing Moon Night Light 16 Colours 15cm with Wooden Stand Remote & Touch Control and USB Rechargeable Gift for Girls Boys Kids Women Men Birthday

Product Information

For my base design, I had a hollow base with a diameter of 6 inches (152.4mm) and walls of 3mm wide. The cylinder in the middle had a diameter of 1.8 inches (45.72), just a little smaller than the hole of the sphere because you will need to wrap your LED lights around this cylinder. The walls of this cylinder were 1mm wide. The space where the cylinder meets the base should be empty since the wires of the LED lights will need to go through the cylinder. Plan for two holes with diameters of 25mm in the walls of the base and the cylinder; the wires of the LED light will go through them.

I created another sketch on the top of the base and drew two circles with diameters of 45.72 and 35.72 from the center. These are the circles that will form the cylinder Lighting Technology: The lighting technology within levitating moon lamps adds to their ethereal appeal. LED lights are used to illuminate the lunar surface, providing a soft and soothing glow that mimics the moon's natural radiance. With adjustable brightness levels and color temperatures, users can create the perfect ambiance for any occasion. The overall structure of the base is done, but I needed to design a raised ledge to keep the LED light's control box in place. Here is where I used the styrofoam wire cutter to test out my design before implementing it. This step is optional, but if you changed any design measurements I highly recommend testing your control box stand.

A replica of Earth's moon 3D printed in intricate detail levitates above the base as the electromagnetic forces create a magical floating effect. I went to Prusaslicer so I could import the new file. I placed the moon on its bottom using the "Place on Face" option on the sidebar. Then I extruded a cylinder from the sketches on the surface of the base. This cylinder should be at most 127mm long. If you had cut off too much of the moon in Meshmixer, make this cylinder even shorter. Insert the DC connector into the metal ring at the bottom of the moon lamp to charge, the red or blue light is always on during the charging.

My first step was to create a design for my moon and base. If you are following along, you can skip to the next step if you don't plan on changing any measurements. Uses NASA satellite real-time data, through three-dimensional imaging technology to give an accurate scaled down version of the moon. The LED light kit should have an RGB control box with extrusions containing holes. I measured all the dimensions of the control box and the diameter of the holes using the dial calipers. This step is extremely important, measure every part of the control box, especially the extrusions, before purchasing screws.The Levitating Moon™ lamp floats above the base because of the magnetic force pushing the moon lamp away from the base.