AKORD 12mm x 12m Water White Plumbers PTFE Thread Seal Tape Plumbing Joint, 12mm x 0.075mm

Product Information

We have had, over the years, individuals and even some professionals comment that PTFE tape can also be wrapped around olives in compression joints as this will help to create a water tight seal. Applying Teflon tape may seem simple enough, but since it has no adhesive properties, you have to make sure you wrap it in the right direction and in the right spot or you could end up with a balled-up mess. Screw joints together: Run your finger over the loose end of the PTFE tape and push it down into the threads to prevent it coming out when you start screwing the joint up. Teflon tape, properly known as “thread seal tape,” is used in the plumbing industry to seal the threads at the end of a pipe.

Wrap plumber’s tape 2-3 times tightly around leaks in the joint where 2 pipes connect or where there is a small crack in a pipe. Ensure joints are clean, dry and free from any debris: Once you have cleaned off all the major crud and debris from your joints ensure they are fully dry as the presence of any moisture can cause leaks.Starting at the open end of the joint come in 1 – 2 threads (as any stray debris from the tape won’t then spill into the open end of the joint) unwrap the PTFE tape from feel and flatten it out, removing any creases and lay over the thread. As prevention is certainly better than cure in this case, for any plumbing joints that are hidden or hard to reach such as those being kitchen units, it’s not a bad idea to add some PTFE tape to ensure no leaks occur at any point in the future as in most cases you’ll never find a leaking joint until the damage has already been done. This PTFE tape comes pre-cut to a specific width and is then wound on a spool so you can decide how long your piece needs to be. One question that often gets asked when using PTFE tape is; exactly how much tape should you use on a typical joint? Commonly known in the UK as “Portable Jointing Compound” and in the US often known as “Pipe Dope” these products are also used to help seal up threads in pipe joints.

You will also learn about exactly what PTFE tape is, the different types of PTFE tape and where exactly on plumbing joint it should be used. As we have discussed above, PTFE tape can be used on pretty much any domestic water-based plumbing system to help prevent the potential of any future leaks forming. standard white PTFE tape can in most cases be safely used with systems that utilise and work with these fuels as the tape itself is able to deal with heat and pressure rather well and due to the fact that PTFE tape won’t react with any such substances it won’t degrade. Just make sure the water is off, then unscrew the shower head and arm and wrap the male threads 2-3 times with plumber’s tape, then screw everything back together and test the shower. That being said we have found in many situations that despite not tightening a compression joint too much and doing everything that’s required to ensure a successful joint, the slightest pin prick hole can cause a leak and adding a little PTFE tape to the thread can certainly prevent this.

You don’t need to use plumber’s tape on unthreaded joints, which you should use a liquid sealant for. One final very important point to be aware of is that you can indeed use both PTFE tape and also Plumbers Mate or another similar jointing compound together for the best and most comprehensive sealing solution. The polytetrafluoroethylene tape range comes in gas grade and potable (drinking) water grade and is available in singles or multipacks. Make sure to wrap all the male threads on new shower heads and shower arms 2-3 times with plumber’s tape before screwing them together.